Grip Cords

Summary	Main Characteristics	Notes - Related Units
These cords allow the Motor Drive (with the Ni-Cd Control Pack) or Winder to be fired using the Motor Drive Release Button on the Power Bounce Grip 2 or the electronic flash T45.	The M.Grip Cord Cord 1 connects the Motor Drive 1 (or 2) / Ni-Cd Control Pack 1 (or 2) assemblage, or Winder 1 (or 2) with the Motor Drive Release Button incorporated in the Power Bounce Grip 2 for comfortable motor driven off-camera flash photography. The M.Grip Cord Cord 2 connects the Motor Drive 1 (or 2) / Ni-Cd Control Pack 1 (or 2) assemblage, or Winder 1 (or 2) with the Motor Drive Release Button incorporated in the electronic flash T45 for comfortable motor driven flash photography.	Before connection or disconnecting, switch the Motor Drive or Winder off. If being switched on, the Motor Drive or Winder will be activated wasting a single film frame. The M.Grip Cord 1 has two different plugs; the straight plug goes into the M.Grip Cord Socket of the Power Bounce Grip 2, the angled plug goes into the Remote Control Jack of the Motor Drive of Winder. Because of the lengths of these cords, the Power Bounce Grip 2 or electronic flash T45 can only be mounted on the right hand side of the camera. Therefore, the M.18V Control Grip cannot be used. Use the M.15V Ni-Cd Control Pack 1 (or 2) instead.